ETAP Power System Studies Course with ETAP Expert
https://FreeCourseWeb.com
MP4 | Video: h264, 1280x720 | Audio: AAC, 44.1 KHz
Language: English | Size: 2.88 GB | Duration: 3h 49m
Power System Studies in detail, Load Flow Analysis, Short Circuit Analysis, Motor Starting Study, Relay Coordination etc
What you'll learn
Overview of ETAP Capabilities
One-Line Diagram/One line View (OLV) creation in ETAP
Understanding ETAP software interface
Understanding ETAP Library
Creating and merging different revisions, presentations, and configuration
Scenario, Study and Project Wizards
Crystal Reports and Customizations
AC and DC Element Descriptions
Load modelling, Types of Loads
Electrical systems modelling and fundamentals
Load flow (balanced and unbalanced) analysis
Load flow analysis and cable sizing
Extraction of Reports and analysis
Transformer sizing Calculation
Benefits of calculated short circuit currents
Introduction to fault current calculations in brief
Breaking and making currents and thermal capacities.
Different typical values of positive, negative and zero phase sequence impedance
Calculation of Isc by impedance method
Calculation of Isc by symmetrical components
Calculations as defined and recommended by IEC/ANSI standards
Fault-Levels
Switchgear/Fuse Rating
Typical cases for switchgear sizing
Relay co-ordination and Arc Flashing studies
Procedures
Data Collection
Plotting Time/Current Curves
Relay Coordination Intervals
Equipment damage curves for cables, transformers
System Modelling for Device Coordination Study
ETAP Star (Device Co-ordination/selectivity)
System earthing (solid, resistance and reactance or even ungrounded systems)
Substation grounding grid design and Calculations
Motor Parameter Estimation
Motor Acceleration Analysis (Dynamic and Static)
Test simulation cases using ETAP
Report evaluations and Summary
HANDS ON PRACTICE: Load Flow Analysis, Report Manager and Transformer Overloading, Short Circuit Analysis, Arc Flash Study, Motor Starting, Relay Coordination
Requirements
Should Have Computer of Laptop for Study and Practice
Good Internet Connection
ETAP
AutoCAD
Description
Course Overview
Power system equipment are meant for normal operation wherein the voltages and currents should be within the tolerable limits. However due to multiple reasons its likely there can be abnormalities in the power system. Hence it’s not only necessary to design equipment to withstand the thermal stresses due to any abnormalities such as faults but also isolation of the equipment thereby protecting the equipment and simultaneously operation of the healthy equipments of the power system.
